Windows 10
## 操作
操作：按照如图所示连接拓扑图 image.png
```bash
# 进入特权模式
Switch>enable
# 进入全局配置模式
Switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
# 进入端口
Switch(config)#interface FastEthernet0/1
Switch(config-if)#
# 禁用
Switch(config-if)#shutdown
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to administratively down
Switch(config-if)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to down
使能
Switch(config-if)#no shutdown
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up
